FDM-S2 SDR Receptor (Software Defined Radio) Maximize

FDM-S2 SDR Receptor (Software Defined Radio)

FDM-S2

Availability:STOCK

525,00 € tax incl.

WhatsApp0034635529114

El receptor SDR FDM-S2 es parecido en ciertos aspectos al FDM-1: La caja del FDM-S2 es algo más grande, la interfaz y los conectores son casi idénticos, también pueden usarse las placas SFE para experimentación ( ver abajo).

The most important difference between FDM-S1 and FDM-S2 is the AD converter and the directly covered frequency range. Because the AD converter of the FDM-S2 is of a newer generation, it is more efficient: it scans faster and with higher resolution. Consequently the direct (without 'undersampling') covered reception range is increased, with the FDM-S2 up to 52 MHz (FDM-S1: 30 MHz). Additionally the new AD converter has a word length of 16 Bit, which allows for a finer resolution and an improved dynamic range. Another consequence of the new AD converter is the improved receiver in the VHF range (with undersampling). This way the FDM-S2 receives WFM without problems and the RDS signal is decoded as well. For better VHF support the FDM-S2 has its own, second antenna input (SMA connector). Please notice: VHF range is not available continuously, but only from 74 to 108 MHz and from 135 to 160 MHz.

Another improvement of the more efficient hardware is utilised by the included FDM-Sw2 software: It can now decode up to 4 'virtual' receivers in the same passband. Adjust every receiver independently to operating mode, filter, volume, squelch and so on.

No customer comments for the moment.

2 other products in the same category: