OM POWER OM2200AMaximize



Availability:Ordered only on customer request, down payment required, delay at c. 20 days.

5 159,99 € tax incl.


The linear amplifier OM2200HF is designed for all short wave amateur bands from 1.8 till 29 MHz (including WARC – bands ) and all modes . It is equipped with a ceramic tetrode FU-728F.

Specification of OM2200HF

Frequency coverage:amateur bands 1.8 – 29.7 MHz including WARC
Power output:2200+ W in SSB and CW
2000 W in RTTY, AM and FM
Driver Power:usually 40 to 60 W for full Output Power
Input impedance:50 Ohm VSWR < 1.5 : 1
Output amplification:17 dB
Output impedance:50 Ohm unbalanced
Maximum output SWR:2:1
SWR protection:Automatic switching to STBY, when reflected power is 350W or higher
Intermodulation distortion:32 dB below nominal output
Suppression of harmonics:< -50 dBc
Tube:FU728F Ceramic tetrode
Cooler:Centrifugal blower + axial blower
Power supply:1 x 230 V - 50 Hz single phase
Transformers:1 pc of toroidal transformer 3.0 kVA
Protection circuits:- SWR too high
 - Anode current too high
 - Screen current too high
 - Grid current too high
 - Mistuning of power amplifier
 - Soft start for protecting your fuses
 - “switch –on blocking “ at opened amplifier
Bar graph indications:- Power output – bar graph 50 LED
 - Reflected power – bar graph 20 LED
 - Current at screen ( Ig2 – bar graph 10 LED )
 - Anode voltage, anode current, tuning – bar graph 30 LED
LED indicators:- current at control grid ( Ig1 – 2 LED )
 - WAIT – preheating of tube (180 sec )
 - STBY– standby
 - OPR – operating condition
 - FAULT – failure, switching off for abt. 4 sec
Parameters:485 x 200 x 455mm (width x height x depth)
Weight:30 kg

No customer comments for the moment.